How can I know that the flips on my 3D Lenticular prints will look fine?

There is no way to get an exact on-screen preview of how the final lenticular flip will print, since the effect only fully comes to life on the physical lens. That said, following a few guidelines gives you the best possible result.

• Use frames with strong, clear differences so each flip reads distinctly
• Keep the number of transition frames modest so each stays crisp
• Avoid tiny text or fine detail in the areas that change during the flip
• Build files at 300 DPI so the interlaced image stays sharp
• When in doubt, ask your printer to review your setup before it goes to print